Refitting The Gear Interlock Plunger And Pawl Assembly - Ducati Diavel Workshop Manual

Gearbox assembly: gearchange mechanism
Unscrew the clutch-side crankcase half screw (3) and remove the pawl (4), washer (2) and spring (1).

Refitting the gear interlock plunger and pawl assembly

On the special screw (3), fit the gear pawl lever (4), orienting it as shown in the figure, the washer (2) with the square
edge side (D) facing the clutch-side crankcase half, and the spring (1), positioning it so that the hook end (A) is facing
the gear pawl lever. Locate the hook end (A) of the spring on the gear pawl lever as shown in the figure.
Apply threadlocker to the screw thread. Start the screw in the crankcase half. Position end (B) of the spring so that it
rests against rib (C) of the crankcase half, as shown in the figure. Tighten the screw (3) to a torque of 18 Nm (Min. 16
Nm - Max. 20 Nm) (Sect. 3 - 3, Engine torque settings). Manually move the gear stopper to check for proper spring
operation.