Removing Of The Abs Control Unit - Ducati Diavel Workshop Manual

System components
Refit the rear mudguard
Refit the rear wheel
Refit the silencer

Removing of the ABS control unit

Operations
Remove the saddles
Remove air conveyor covers
Remove the tank half covers
Remove the fuel tank
Drain the hydraulic fluid that is inside the front and rear braking system tubes by disconnecting them from the master
cylinder and the calliper (Sect. 4 -3,
Disconnect the connector (A) of the ABS control unit (6).
Loosen the screws (16) that retain the ABS control unit support (12) and remove it from the vehicle.
Undo the four special screw (17) fixing the pipes (10), (9), (8) and (7), on the ABS control unit (6), removing the gaskets
(11).
Warning
Every time that gaskets (11) are removed, they must be replaced with new gaskets (11).
Important
5 - 4, Refitting the front mudguard
7 - 2, Refitting the rear wheel
8 - 8, Refitting the exhaust system
Section reference
5 - 3, Removal of the seat
8 - 7, Removal of the air filters
5 - 2, Removal of the fuel tank
fairings
8 - 2, Removal of the fuel tank
Changing the brake fluid).