Replacing Of The Rear Sprocket - Ducati Diavel Workshop Manual

Final drive
Warning
Carefully check the two pins: the figure shows the correct result of the procedure.
Adjust the chain tension (Sect. 4 - 3,
Apply the recommended threadlocker to the screws (11).
Fit the sprocket cover (10) tightening the screws (11) to the torque of 6 Nm± 10% (Sect. 3 - 3,

Replacing of the rear sprocket

Operations
Slacken the chain
Remove the exhaust silencers
Remove the rear wheel
Lock the wheel axle rotation.
Remove the clip (1).
Loosen the locking nut (2) with a socket wrench.
Fully unscrew the nut (2) and remove the washer (3) and the flange (5) with the sprocket (17).
Collect the spacer (9).
Using a mallet, tap the flange (5) with the cush drive damper (6) off the sprocket (17).
Adjusting the chain tension).
Section reference
4 - 3, Adjusting the chain tension
8 - 8, Removal of the exhaust
system
7 - 2, Removing of the rear wheel
Frame torque settings).