Protection And Safety Devices; Checking Protection And Safety Device Components; Checking The Fuses - Ducati Diavel Workshop Manual

Protection and safety devices

6 -Protection and safety devices

Checking protection and safety device components

Checking the side stand switch
Remove the switch (1) from the side stand undoing screw (2) and disconnect the main wiring connector from the switch
(see paragraph "Routing of wiring on
Use an analogue or digital multimeter (Sect. 6 - 11,
operation (see table).
Note
The same test may be carried out using the "DDS" tester (Sect. 6 - 11,
Pos. pin (A)
l - s
s - n
Multimeter pos.
0 = Open contact
X = Closed contact
Refit switch (1) to side stand and tighten the screw (2) to a torque of 5 Nm ±10 (Sect. 3 - 3,

Checking the fuses

The main fuse box (1) and the secondary one (2) are located in the tool tray; to reach the fuse box remove the seat as
specified under Sect. 5 - 3
The fuses are accessed by removing the cover, which shows the ampere ratings and mounting locations.
For ampere ratings, refer to the chapter
Important
Before replacing a damaged fuse with a new one of the same rating, identify the cause of the problem.
A blown fuse can be identified by the breakage of inner filament (A).
frame", Sect. 6 - 1).
El. item
0
X
Green/
Green
White
"Removal of the seat".
"Routing of wiring on
Using a multimeter to check the electrical
Diagnostic
Rating
X
0
Green/
Yellow
Black
frame", Sect. 6 - 1.
systems) to check switch
instruments).
Frame torque settings).