Ducati Diavel Workshop Manual page 540

Hide thumbs Also See for Diavel:

Table of Contents

Tail light - number plate holder

Fit the number plate holder plate (8) to the number plate support subframe (9), fitting the special screws (6) into the

vibration dampers and starting the nuts (10) on the opposite side.

Slide the plate (8) along the slots (G) in the subframe (9) until bringing it all the way towards the bottom side.

Tighten the special screws (6) to a torque of 5 Nm ± 10% (Sect. 3 - 3,

Frame torque

settings), by holding the nuts (10)

on the opposite side.

Chapters

Table of Contents

Diavel carbon