Glass Removal - Vermont Castings CDVR33n Installation And Operating Instructions Manual

GlaSS ReMoVal & RoCk wool plaCeMenT
GlaSS FRaMe ReMoVal
1. Remove upper and lower louvers.
. Release the clamps on the bottom of the fireplace.
Figure 54
3. Tilt glass frame out and lift glass frame up until it clears
the hook on top of the frame.
4. Set glass frame aside.
each clamp has a quick spring
force. when reinstalling
clamps, keep fingers clear.
WARNING
noTe: A mesh glass cover is available for this fireplace.
This cover is recommended to reduce the severity of burns
in case of accidental contact. Refer to the Accessories list
on Page 55.
AVERTISSEMENT
RoCk wool plaCeMenT
1. For best results in flame appearance and opera-
tion:
a. If your fireplace was supplied with three (3) 8-
gram bags of rock wool embers: Use one (1) 8
gram bag or rock wool for propane/LP models
and up to three (3) bags of rock wool for natural
gas models depending on the size of your fire-
place.
b. If your fireplace was supplied with one (1) 40-
gram bag of rock wool embers: Use no more than 1/5
(8 grams) of the total amount of rock wool supplied
in the 40 gram bag for propane/LP models and up to
3/4 of the 40 gram bag of rock wool for natural gas
models depending on the size of your fireplace.
Use the following chart as a guide to how much rock
wool to use:
Models
CDV33, CDV36 4 grams max.
CDV4, CDV47 30 grams max.
69D3011
Glass Frame
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
causer des brûlures.
Laissez refroidir le panneau
vitré avant d'y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.
natural Gas lp
8 grams max.
1 grams max.
CDVSC7 & CDV7 Series Gas Fireplace
Clamps -
 on 33/36 Models,
3 on 4/47 Models
Figure 54 -
Removing Glass Frame - CDVR Series Shown
FP2297
remove glass
The use of too much rock wool could
cause flame to burn poorly and may cause
sooting.
Cover with
Rock Wool
Figure 55 - Placement of Rock
FP2648
Wool on Burner
BDV rock wool place
. Pull the rock wool apart into dime-sized pieces or
smaller. Cover the entire surface of the burner with one
thin layer of rock wool.
3. Place the logs on the burner. Refer to the "Log Place-
ment Section". Light the unit and after 15 minutes check
burner flame and glow. Adjust embers as necessary to
achieve an even and clean flame.
Burner
FP97
FP648
45