Electrical Installation; Remote Wall Mounted Switch; Remote Wall Switch; Optional Dc Remote Systems - Vermont Castings CDVR33n Installation And Operating Instructions Manual

eleCTRICal InSTallaTIon

ReMoTe wall MounTeD SwITCh

A remote wall switch and up to fifteen (15) feet of 18 Ga.
wire may be used with this appliance. Attach the wall
switch in a junction box at the desired location on the
wall. Figure 43. Do not extend beyond the wall switch wire
length provided.
noTe: Extended lengths of wire may cause the fireplace
not to function properly. Longer length of wire is permitted
if the wire is made out of larger gauge (diameter) wire.
Always check with local code.
PILOT HI
TH
TP
TH/TP
Figure 43 -
Wiring Diagram for Wall Switch

ReMoTe wall SwITCh

Position the wall switch. Do not extend beyond the 15 feet
of wire.

opTIonal DC ReMoTe SySTeMS

See section entitled Hearth Mount in the Millivolt hand held
remote instructions supplied with the remote.
1. Using a flat head screw driver, bend the "remote" tabs
up from the bottom of the fireplace. Figure 44
. Follow the instructions on remote control to snap the
remote cover plate to the remote receiver
3. Connect the wire terminal from the remote receiver.
Figure 43
4. Use the screws that came with the remote control to
mount the remote receiver cover to the bent up "remote"
tabs. Figure 44
69D3011
ON RS
OFF
FP1980
Dv wiring diagram
'Remote' Tabs
Remote Control
Receiver
Figure 44 -
Optional Control Location
CDVSC7 & CDV7 Series Gas Fireplace
Do not connect wall switch to (110 V)
circuit.
OPTIONAL REMOTE
WALL SWITCH
OPTIONAL REMOTE
CONTROL RECEIVER
Blower Speed
Control
FP2284a
CDV7 controls
ON
OFF
ON
OFF
FP1980
FP84a
9