Production Test Errors - Nautilus Be Strong Commerical T912 Service Manual

SECTION 4: T914/916 TROUBLESHOOTING ELECTRICAL PROBLEMS
Table 4–3. Error List
Display Type
TM HW COM Error
ERROR
TM COM ERROR Error
DRIVE ERROR Error
OUT CUR ERROR Error
BELT OVRLD Warning
ERROR
SYS OVRLD Error
ERROR
DRV MON ERROR Error
CONFIG RQRD Error
GRD LIMIT Error
ERROR
GRD MOVE Error
ERROR
SPD CHANGE Error
ERROR
STUCK KEY Error
Table 4–4. Production Test Errors (requires special equipment to test console, see
factory)
Display Type
CS HW COM Warning
ERROR
CS COM ERROR Warning
Response
Anytime—Goes to idle. Treadmill
slowly stops.
Anytime—Goes to idle. Treadmill
slowly stops.
Program operation—Goes to idle.
Treadmill stops quickly.
Program operation—Goes to idle.
Treadmill slowly stops.
During movement—Displays
message until the user presses
CLEAR.
Program operation—Goes to idle.
Treadmill slowly stops.
Program operation—Goes to idle.
Treadmill slowly stops.
Start-up—Stops operation.
During change—Goes to idle.
Treadmill slowly stops.
During change—Goes to idle.
Treadmill slowly stops.
Program operation—Goes to idle.
Treadmill slowly stops.
Start-up—Stops operation.
Response
Start-up—Stops CSAFE but
continues user selection.
Anytime—Stops CSAFE but
continues program.
Nautilus® Commercial T9 Series Treadmill Service Manual
Description
Treadmill UART hardware link failure.
Treadmill drive communication failure.
Treadmill drive (VSD) failure, possible
output switching fault recycle power
and determine if failure is intermittent.
Treadmill output current too low.
Treadmill moderate drive overload.
Designed to inform the user that the
belt or deck will need to be replaced
soon.
Treadmill high drive overload.
Treadmill current monitoring circuit
failure.
Treadmill configuration not allowed
or device needs to be configured.
Treadmill grade position outside
limits.
Treadmill grade system detected an
non-requested response.
TM drive is commanded to change
speed but doesn't.
One of the keypad keys are stuck in
an active state. Reports only "Stuck
key."
Description
ALL—CSAFE UART hardware link
failure.
ALL—CSAFE communication failure.
55