LG-Ericsson LDP-7008 D User Manual page 184

LIP-7008D
9. Working with PBX, Centrex & ISDN features
9.1 Access PBX or Centrex
The iPECS has been designed to operate with a host PBX system or
Centrex services from your service provider. The iPECS connects to
such a host with analog CO lines.
When accessing a CO line, the phone will act as an extension of the host,
allowing access to the host system features using the host dial codes.
While on a call, use the iPECS Flash feature to transfer calls to other
host extensions or access features of the host. The Flash feature may
be used on other CO lines to regain dial tone from the CO line without
relinquishing control of the CO line to place another call.
OPERATION
To access PBX or Centrex features while idle:
 Lift the handset,
 Select/dial access a PBX/Centrex CO line,
 Dial PBX/Centrex feature code.
To access PBX/Centrex features while on a PBX/Centrex CO line:
 Press F
LASH
 After receiving new dial tone, dial PBX/Centrex feature code.
9.2 Access the ISDN Network
9.2.1 Using the Keypad facility to access ISDN features
Access to certain features of your ISDN services requires that dialed
digits be sent to the ISDN as data and not tones. In this case, dialed
digits are sent as 'Keypad messages'.
A
KEYPAD FACILITY
procedures.
program
however, actions other than dialing will deactivate the 'Keypad message'
operation.
OPERATION
To activate Keypad Facility operation:
 Press the K
 Dial as desired.
To deactivate Keypad Facility operation:
 Press K
EYPAD
Or
 Press a Feature or Flex button.
,
button must be assigned using the
Once active, dial into the ISDN for services;
F
EYPAD ACILITY
F ,
ACILITY
button to switch to keypad mode,
42
User Guide
Flex Button