LG-Ericsson LDP-7008 D User Manual page 182

LIP-7008D
8.5 Alarm/Door Bell
The system can monitor external Alarm or Door Bell contacts:
Alarm Monitor—should the external contact activate, a unique Alarm
Ring signal and LCD display may be received. To restart the monitor
circuit, the external contacts must be deactivated and the Alarm Ring
signal terminated.
Door Bell—a unique Door Bell Ring (single tone burst) may be received
each time the external contact is activated. A system contact also can
be controlled to act as a Door Open contact.
OPERATION
To terminate the Alarm signal:
 Dial 565 (Alarm Stop code).
To activate the Door Open contacts:
 Lift the handset,
 Dial Door Open
NOTE—Contacts 3 & 4 are only available in the iPECS -300 & 600.
—Contacts 1 is available in the iPECS -MG.
8.6 Power Fail Transfer
When AC power to the system fails, back-up operation may be provided
with back-up batteries or Power Fail Transfer (PFT). When battery
back-up is provided, the station will operate normally. When PFT is
implemented, a SLT is connected to a CO line by the system. This SLT
can be used as any normal SLT, providing service while power is out.
8.7 System Voice Memo
The integrated Voice Mail modules incorporate several Voice Memos to
provide Station Users with general information such as station number,
date, time, and feature status.
speaker of the iPECS Phone and over the handset for SLTs.
For the Station Status Memo, the following items are reported:
ICM Signaling Mode (Handsfree/Tone/Privacy)
Station IP Address
Station Mac Address
Number of messages x (x: number of all message waiting)
Wake-Up Time (hh:mm)
Do Not Disturb
Forwarded to station xxx
code #* and contact number 1 to 4.
Voice Memos are heard over the
40
User Guide