Setting The Time - Digimerge DH200+ Series Instruction Manual

Setting the Time

It is highly recommended to set the time on the system prior to doing any recording.
All recording must be stopped on the system in order to set the time.
NOTE:
Figure 5.0 Time menu
To set the date and time:
1. Stop recording on the system by pressing
on the remote control and enter your 6-digit system password (by default, 000000).
If using the mouse, right-click and then click
NOTE:
2. Press the MENU button to open the system menu. Select SYSTEM and press the ENTER
button. The System menu opens.
3. Select the TIME tab.
4. Select DATE and enter the date (mm/dd/yyyy).
5. Select TIME and enter the time (hh/mm/ss).
If using the mouse, use the Virtual Keyboard to enter the date and time.
NOTE:
6. Press the ENTER button to save your changes.
7. Press / on the front panel, or press the
Continuous Recording.
If using the mouse, right-click and then click
NOTE:
/ on the front panel, or pressing the
on the Virtual Remote.
button on the remote control to resume
on the Virtual Remote.
Using the System
button
13