Digimerge DH200+ Series Instruction Manual page 31

2. Click to save your settings.
CONTI. is set to 30F/S.
This means Channel 2 will
record at 30 FPS during
continuous recording.
Motion is set to ON. This
means the system will
start motion recording
when the system detects
motion.
Step 2 of 2 : Configure Motion Recording frame rates
1. From the Main Menu, click EVENT (
2. Configure the following beside the channel that has motion enabled:
• MOTION: Select the frame rate the system will record at when it detects motion (i.e 30F/S)
• Select the recording quality (LOW, MIDDLE, SUPER, HIGH, ULTRA)
3. Click to save your settings
Final Results
• The system records continuously with the assigned parameters. In this example, the system
will record at 15 FPS during continuous recording.
• When the system detects motion, Motion recording begins. In this example, the system will
record at 30 FPS when motion is detected (Motion Recording).
• When the post-alarm recording ends, Motion recording stops, and continuous recording
resumes at 15 FPS.
).
Enter the image
Enter the desired
quality during
recording frame rate
Motion recording
during Motion
recording
Recording
21