Buderus Logamax plus GB162 Applications Manual page 44

Gas condensing boiler
Hide thumbs Also See for Logamax plus GB162:
Table of Contents

Advertisement

4 4 |
Programming - System 4
Enter the service level in RC35 control as described in the
Installation and Service instructions or on chapter 2.4.2.
Important parameters:
Go to settings, press MENU/OK
Turn dial clockwise until Did you install a low loss header
module? appears. Select Yes.
Turn dial clockwise until Is heating zone #1 installed
(unmixed heating zone)? appears. Select Yes.
Press RETURN and select heating zone #1, press MENU/
OK
Turn dial clockwise until Should heating zone #1 be
activated? appears. Select Yes.
Turn dial clockwise until Which user interface is assigned
to heating zone #1? appears. Select RC35 if the unit is
mounted in a representative room for room reset or outdoor
reset with room feedback.
Turn dial clockwise until Has a solar module been
installed? appears. Select Yes.
Set up the remainder of the parameters according to the
Installation and Service instructions.
See also chapter 2.4 for additional information on the RC35.
Technical specifi cations are subject to change without prior notice
GB162 Applications Manual
Fig.35 RC35 overview
SERVICE MENU
quick operation
settings
diagnosis
servicing
Fig.36 RC35 service menu view
Logamax plus GB162 applications manual | 03.2013

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents