1.
NOTE FOR REPAIR
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some pieces of
gilt may be left inside)
Do not fold down a flat cable at the edge of the inforcing board
which is the reverse side of pins when the flat cable is connected
to a connector.
If the flat cable is folded at that point, it may be a cause of
breaking of foil inside of the cable.
SERVICE NOTE
When remove a connector, don't pull at wire of connector.
It is possible that a wire is snapped.
When installing a connector, don't press down at wire of connector.
It is possible that a wire is snapped.
– 7 –
DSR-25