Connection Of Equipment - Sony DSR-25 Service Manual

DSR-25
3-1-2.

Connection of Equipment

According to the specification for the input terminal (S VIDEO
input or VIDEO input), connect measuring equipment as shown in
Fig. 5-3-1, and make adjustment.
The input terminal is specified in ( ) of the signal column.
Any input terminal can be used unless otherwise specified.
To switch between S VIDEO input, VIDEO input and DV input,
use the INPUT SELECT switch.
• When a pattern generator without
the Y/C separator terminal is used.
Pattern generator
• When a pattern generator with
the Y/C separator terminal is used.
Y OUT (75 Ω)
CHROMA
OUT (75 Ω)
Pattern generator
When S VIDEO is specified
VTR with S VIDEO terminal (E-E mode)
VIDEO IN
S VIDEO OUT
VIDEO OUT
(75 Ω)
Note 1: In adjustments specifying for the S VIDEO input to be
used, using the VIDEO input would disable the product
specifications of this unit from being satisfied. Always
use the input signal specified.
Note 2: If adjustments are used with the VTR with the S video
output terminal as the signal source, the performance of
this unit may be affected by the VTR. Use a pattern gen-
erator with a Y/C separator terminal as much as possible.
When VIDEO is specified
Pattern generator
VIDEO OUT
(75 Ω)
MONITOR TV
Fig. 5-3-1
5-42
Adjustment
remote
commander