17
SERVICE WORK ON THE ENGINE
17.5
Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear of the transmission.
The gear oil must be added while the engine is cold.
–
Mount and tighten the screw cap.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
x
Preparatory work
–
Park the motorcycle on a level surface.
Main work
(All 125/200 models)
–
Remove screw
B00049-10
(All 250/300 models)
–
Remove screw
B00050-10
–
Remove screw cap
–
Add gear oil until it emerges from the opening used to check the gear oil level.
Engine oil (15W/50) (
–
Mount and tighten the screw in the opening used to check the gear oil level.
Guideline
(All 125/200 models)
Screw, gear oil level check
B00053-11
(All 250/300 models)
Screw, gear oil level check
–
Mount and tighten screw cap
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 103)
from the opening used to check the gear oil level.
1
from the opening used to check the gear oil level.
1
.
2
p. 129)
.
2
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
M6
10 Nm
(7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
105