11
SERVICE WORK ON THE CHASSIS
11.10
Installing the fork protector
11.11
Removing the lower triple clamp
Main work
–
Remove screws
–
Remove the screws on the right fork leg. Lift off the fork protector.
B00801-10
x
Main work
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B00801-10
Finishing work
–
Install the fork legs.
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
(EXC EU/AUS, XC‑W)
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Remove screw
dlebar and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
B00805-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
B00806-10
on the left fork leg. Lift off the fork protector.
1
(
p. 48)
x
(
p. 82)
x
p. 92)
(
p. 82)
x
(
p. 48)
x
p. 56)
. Loosen screw
. Take off the upper triple clamp with the han-
1
2
. Remove protective ring
3
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 90)
p. 46)
p. 90)
.
4
50
.
1