KVH Industries TracVision RV1 Installation Manual page 30

A Continued
Configure the IP AutoSwitch
When performing system setup (see
System" on page 22), follow these additional
steps to configure the IP AutoSwitch.
NOTE: KVH recommends that you run the Setup
Wizard in the web interface whenever you change
your system's configuration by adding or removing
devices.
a. At the AutoSwitch page of the web interface,
select Add IP AutoSwitch (Figure 48).
b. Enter the serial number and choose a friendly
name for the IP AutoSwitch (for example,
"Master Bedroom").
c. Select Save to save your changes.
Select the Master Receiver
Any receiver connected to an IP AutoSwitch can
become the master receiver for the system. The
master receiver controls satellite selection.
IMPORTANT!
The TV-Hub has a built-in IP AutoSwitch.
Any receiver connected directly to the TV-
Hub can therefore be selected as a master
receiver through the web interface.
a. To choose the master receiver, select it on the
Home page of the web interface, or press the
Master Select button on the associated
IP AutoSwitch.
b. Verify that the LED in the Master Select
button on the IP AutoSwitch is lit green (see
Figure 49). The LEDs for any other IP
AutoSwitches should be lit orange.
Installing an IP AutoSwitch
Figure 48: Add IP AutoSwitch Screen
"Set Up the
Figure 49: IP AutoSwitch LED Status Indications
LED Color
Orange
Orange,
flashing
Red
Green
140701234
Indication
Registered with the system but
not currently the master
Initializing
Error:
• unable to communicate with
the system,
• network is not detected, or
• unable to register
Registered with the system
and currently the master
29