Operator panel bezel removal
1
Lift the flatbed scanner on the right side.
2
Lift the bezel away from the operator panel, and remove.
Note: The picture below shows the bezel removal for the CX310 and CX410 models. The bezel for CX510 models
is removed the same way.
Operator panel logo plate removal
1
Pull the logo plate forward from the bottom to pop it loose from the operator panel.
2
Remove the operator panel logo plate.
Note: The CX510 bezel is larger and requires a higher force to remove. It does not need to be removed except for
replacement.
Repair information
282
7527