Philips Q552.2L Service Manual page 17

4.3 Assy/Panel Removal Berlinale styling
(xxPFL5806D/78)
Instructions below apply to the 32PFL5606H/12, but will be
similar for other models.
4.3.1 Rear Cover
Refer to Figure 4-9 for details.
2
2
2
4.3.2 Small Signal Board (SSB)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from both the LVDS Flat Foil connectors
that connect with the SSB.
Caution: be careful, as these are very fragile connectors!
Take the flat foils out of their connectors.
2. Unplug all other connectors.
3. Remove all fixation screws from the SSB. Note that one
screw is located below the upper flat foil cable.
4. Take out the SSB together with side and bottom I/O
bracket.
5. Remove the screws between the bottom Y-Pb and L-R
audio connectors.
6. Remove the side and bottom I/O bracket from the SSB.
Note that these parts are kept in place by very fragile clips.
Release those clips gently!
Mechanical Instructions
1
3
1
2
Figure 4-9 Rear cover removal
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove screw caps [1] that cover VESA screw holes.
2. Remove all fixation screws [2] that secure the rear cover.
3. At the indicated areas [3] the cover is secured by clips. Be
very careful with releasing those.
4. Lift the rear cover from the TV. Make sure that wires and
flat foils are not damaged while lifting the rear cover from
the set.
2
4.3.3 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Release the tape from the Power board cables.
2. Unplug power connectors from the SSB, as it is not unplug-
able at the PSU itself (soldered connector).
3. Unplug both other connectors from the PSU.
4. Remove all fixation screws from the PSU.
5. The PSU can be taken out of the set now.
When defective, replace the whole unit.
4.3.4 Stand removal
1. Remove the four fixation screws.
2. Take the stand out in a downwards direction.
back to
div. table
Q552.2L LA 4.
2
1
3
2
1
2
19080_107_110401.eps
EN 17
2
2
110407
2012-Mar-16