Table of Contents
Advertisement
System Components
The Camera Module system comprises the following optional products.
Camera Module
C-mount lens
VCT-ST70I
tripod adaptor
Network card
(commercially available)
LAN cable
(commercially available)
Electric wires for signal inputs
(commercially available)
Power supply cable (The 2-pin
connector is supplied as an
accessory.)
DC power supply
(commercially available)
For More Information Please Call Aegis Electronic Group, Inc. * (888) 687-6877 Phone * aegis-g2@aegiselect.com * http://www.aegis-elec.com
This is a small-size, high-resolution, video camera module using a progressive scan CCD image
sensor.
Use a high-resolution lens.
This attaches to the bottom of the camera module to fix the camera module to a tripod.
Install the board in the expansion slot of the host device (ex: computer). Select a card that is
appropriate for your system and that supports 1000BASE-T and jumbo packets.
This cable connects to the RJ45 connector on the rear panel of the camera module. Image/control
signals are transmitted via this cable. Select a LAN cable that supports 1000BASE-T (CAT5e or
higher cable standard).
Depending on the attributes of the LAN cable, images may become less clear and the camera
module may become unstable. Be sure to use a LAN cable that has sufficient noise reduction.
To be connected to the 7-pin GPIO
Attach commercially available electric wires to the connector to be connected to the power
receptacle.
Note
Use electric wires allowed for DC 20 V or higher and 0.5 A or higher.
Use a power supply allowed for DC 10.5 V to DC 15 V or higher and 1 A or higher.
5
Advertisement
Table of Contents
