Surround Panel & Circuit Board Installation - Lopi Pioneer Bay Operation Manual

Lopi pioneer bay pellet insert operation manual
Hide thumbs Also See for Pioneer Bay:
Table of Contents

Advertisement

Surround Panel & Circuit Board Installation
NOTE: Attach the vent prior to installing the surround panels (& circuit board).
The panels are offered in the two sizes shown below:
8 x 10 Panels
10 x 13 Panels
a
b
Attach the control panel
knob with the bolt (both
included with the
surround panels)
7/16" Wrench
Attach the circuit board
with the four screws
shipped with the insert.
Phillips
Screwdriver
Place the right side surround panel near
c
the insert and attach the wiring harness
to the circuit board.
Back Side of
Circuit Board
Pinch these tabs to
remove the wiring
harness.
If using a thermostat,
attach the thermostat
wires at this time.
Wiring Harness
(disconnected
in step "a")
© Travis Industries
Installation
S i z e
Brass Trim #
99300703
99300704
Phillips
Screwdriver
Remove the circuit board from the rear
hopper support. Disconnect the wiring
harness from the circuit board (see step
"c" below for a detailed view).
Run the power cord to the side along
the front of the fireplace behind the side
panel (do not route it under the insert).
e
Install the top panel so the joggle clips slide over the tabs on
Right Side
top of the side panels and insert.
Surround
Panel
NOTE: When installed,
the panels must be 3/8"
off the fireplace face.
Black Trim #
99300709
99300710
Attach the surround panels to the insert by sliding the slots
d
on each panel over the tabs on the side of the insert.
Top Trim
Top
Panel
Double-Back Tape
4 0 8 0 8 1 9
Width
Height
40-1/2"
28-7/8"
44-1/2"
31-7/8"
Slot
Tab
Tighten the set screws
from the back side with a
small standard screwdriver
"L" Bracket
Right Side Trim
Panel Trim Construction:
Insert one leg of each "L" bracket
into the top and side trim piece.
Align the trim to form a precise
corner, then tighten the two set
screws with a small standard
screwdriver. Slide the trim over
the panels. Attach a piece of
included double-back tape to the
bottom of each side trim to keep it
from flaring at the bottom.
9 3 5 0 8 0 5 1
1 1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Heritage bay pi

Table of Contents