Loading Pellets; The Two Modes Of Operation; Operation (Continued) - Lopi Pioneer Bay Operation Manual

Loading Pellets

Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper
holds approximately 35 pounds of pellets.
WARNING:
The front edge
of the hopper
lid becomes
very hot, do not
touch the area
below the
handle.

The Two Modes of Operation:

Manual
Manual mode requires the user to turn
the heater on and off manually.
Auto (requires a thermostat)
Auto mode allows you to use a
thermostat to control room
temperature. The stove automatically
turns on when the temperature drops
below the thermostat setting. Once the
stove reaches operating temperature,
the stove then runs at the heat output
setting selected.
Switching Modes While in
Operation
Whenever the stove is switched from
one mode to another while in
operation, the stove will enter the "start-
up" sequence for a minimum of 20
minutes.
© Travis Industries
Operation
Make sure
pellets are not
left on this
heat shield.
DISCONNECT POWER BEFORE SERVICE
H
E
HIGH
A
T
O MED
U
T
P
LOW
U
T
H
E
A
T
F
A
N
TRAVIS INDUSTRIES
HOUSE OF FIRE
4 0 8 0 8 1 9
NOTE: press the spring here
while closing the hopper lid.
Close the lid slowly to prevent
pinching your finger.
AUTO
MANUAL
These indicator lights
are used to determine
AUGER
which mode you are in.
MAINT.
(REQUIRED)
AUTO
UP OFF
MANUAL
Use the mode
switch to
MANUAL
DOWN
determine the
mode.
UP START
MANUAL
DOWN
AUGER
TM
1 5
9 3 5 0 8 0 5 1