Reset Of Repaired Ssb; Opt. No. (Option Numbers); Option Code Overview - Philips Q528.1E Service Manual

8.4.4

Opt. No. (Option numbers)

Select this sub menu to set all options at once (expressed in
two long strings of numbers).
An option number (or "option byte") represents a number of
different options. When you change these numbers directly,
you can set all options very quickly. All options are controlled
via eight option numbers.
When the NVM is replaced, all options will require resetting. To
be certain that the factory settings are reproduced exactly, you
must set both option number lines. You can find the correct
option numbers on a sticker inside the TV set and in Table

"Option code overview".

Example: The options sticker gives the following option
numbers:
• 04368 00005 01066 08707
• 00000 00032 00512 00000
The first line (group 1) indicates hardware options 1 to 4, the
second line (group 2) indicates software options 5 to 8.
Every 5-digit number represents 16 bits (so the maximum value
will be 65536 if all options are set).
When all the correct options are set, the sum of the decimal
values of each Option Byte (OB) will give the option number.
See table "Option code overview" for the options.
Alignments Q528.1E LA
Table 8-5 Option code overview
CTN Options Group 1
32PFL9632D/10 41641 05122 04439 45160 10046 00066 00000 00000
47PFL9532D/10 41641 04099 04439 45160 10065 00064 00000 00000
Important: after having edited the option numbers as
described above, you must press OK on the remote control
before the cursor is moved to the left!
8.5

Reset of Repaired SSB

A very important issue towards a repaired SSB from a service
repair shop, implies the reset of the NVM on the SSB.
A repaired SSB in service should get the service Set type
"00PF0000000000" and Production code "00000000000000".
Also the virgin bit is to be set. To set all this, you can use the
ComPair tool.
8. EN 121
Displ.
Options Group 2
(code)
62
81