22.Body Integrated Unit - Subaru 2009 IMPREZA Service Manual

Hide thumbs Also See for 2009 IMPREZA:

SECURITY AND LOCKS

22.Body Integrated Unit

1. When replacing the body integrated unit

• Prepare the security ID plate.

• For models with immobilizers, prepare the re-

quired number of new (unregistered) immobilizer

• When replacing the body integrated unit,

check the current settings and record it. <Ref. to

LAN(diag)-22, CONFIRMATION OF CURRENT

SETTING, OPERATION, Subaru Select Moni-

2. After replacing the body integrated unit with im-

• Register the immobilizer. For detailed opera-

tion procedure, refer to the "REGISTRATION

MANUAL FOR IMMOBILIZER".

• Set the current settings as recorded.

1) Disconnect the ground cable from battery.

2) Remove the driver's side instrument panel lower

cover. <Ref. to EI-46, REMOVAL, Instrument Pan-

el Lower Cover.>

3) Remove the knee guard panel.

4) Disconnect the harness connector of body inte-

grated unit.

Be careful to keep water and other foreign ma-

terials away from body integrated unit.

5) Remove two mounting nuts for body integrated

unit bracket, and remove the body integrated unit.

B: INSTALLATION

Install in the reverse order of removal.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Make sure that there are no differences from the

contents of the current settings after installation.

<Ref. to LAN(diag)-22, CONFIRMATION OF CUR-

RENT SETTING, OPERATION, Subaru Select

Body Integrated Unit