Setup Menu Items - Yamaha AVENTAGE RX-A1040 Owner's Manual

Setup menu items

Menu Item
Auto Setup
Setting Pattern
Setting Data Copy
Power Amp Assign
Speaker Configuration
Manual Setup
Distance
Level
Parametric EQ
Test Tone
Delay Enable
Lipsync Auto/Manual Select
Adjustment
Dynamic Range
Max Volume
Sound
Initial Volume
Pure Direct Mode
Adaptive DSP Level
CINEMA DSP 3D Mode
Extended Surround
Video Video Mode
Function
Automatically optimizes the speaker settings (YPAO).
Registers two speaker setting patterns and switches between them.
Copies the "Setting Pattern" parameters in the specified direction.
Selects a speaker system.
Front Selects the size of the front speakers.
Center Selects whether or not a center speaker is connected and its size.
Surround Selects whether or not surround speakers are connected and their size.
Surround Back Selects whether or not surround back speakers are connected and their size.
Front Presence Selects whether or not front presence speakers are connected.
Subwoofer Selects whether or not a subwoofer is connected and its phase.
Layout Selects a surround speaker layout when surround speakers are used.
Bass Cross Over Sets the lower limit of the low-frequency component that can be output from speakers whose size is set to "Small".
Sets the distance between each speaker and listening position.
Adjusts the volume of each speaker.
Adjusts the tone with an equalizer.
Enables/disables the test tone output.
Enables/disables the Lipsync adjustment for each input source.
Selects the method to adjust the delay between video and audio output.
Adjusts the delay between video and audio output manually.
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback.
Sets the maximum volume to prevent excessive loudness.
Sets the initial volume for when this receiver is turned on.
Selects whether to output video signals during the Pure Direct mode.
Selects whether to automatically adjust the CINEMA DSP effect level.
Enables/disables CINEMA DSP 3D.
Selects how to play back 5.1- to 7.1-channel sources when surround back speakers are used.
Enables/disables the video signal processing (resolution and aspect ratio).
CONFIGURATIONS ➤ Configuring various functions (Setup menu)
Page
38
111
111
111
112
112
112
112
112
113
113
113
113
113
113
114
114
114
115
115
115
115
115
115
115
116
116
109
En