D Contest Number Set Mode - Icom IC-7800 Instruction Manual

4
RECEIVE AND TRANSMIT

D Contest number set mode

[F-1•Y] [F-2•Z][F-4•DEF]
• Contest number set mode screen
This item sets the numbering system used for contest
(serial) numbers— normal or short morse numbers.
This selects which of the four memories will contain
the contest serial number exchange. The count-up
trigger allows the serial number to automatically in-
cremented after each complete serial number ex-
change is sent.
This item shows the current number for the count-up
trigger channel set above.
[EXIT/SET] Main dial
4-10
This menu is used to set the contest (serial) number
and count up trigger, etc.
• Setting contents
q During CW mode operation, push [F-3•KEYER] to
select memory keyer screen.
w Push [EXIT•SET] to select memory keyer menu,
then push [F-3•001] to select contest serial number
set mode.
e Push [F-1•Y] or [F-2•Z] to select the desired set
item.
r Set the desired condition using the main dial.
• Push [F-4•DEF] for 1 sec. to select the default condition
or value.
t Push [EXIT/SET] twice to normal screen.
• Normal : Does not use short morse numbers
(default)
• 190➔ANO : Sets 1 as A, 9 as N and 0 as O.
• 190➔ANT : Sets 1 as A, 9 as N and 0 as T.
• 90➔ NO : Sets 9 as N and 0 as O.
• 90➔ NT : Sets 9 as N and 0 as T.
• M1, M2, M3 and M4 can be set. (default: M2)
• Rotate the main dial to change the number, or push
[F-3•001CLR] for 1 sec. to reset the current num-
ber to 001.