Reverse of the machine
In order to attach different implements, the machine can be reversed by turning the handle 180 degrees, as it
is described in this page.
OPERATION TO PERFORM
WHEN THE MACHINE IS
TURNED OFF
Before reversing the handle, you need to take away the levers that control the speed direction and the power
takeoff.
1 – Take the split pins
from the levers
4 – Raise completely the
lever that locks the side
adjustment of the steering
handle
6 – take the handle to the opposite
side, above the engine
Picture 6 - Reverse of the machine
WARNING!!
In the reversed position the levers need to be inverted, so the controls as well are
inverted.
You should refer to the paragraph "Positions and controls of levers".
To perform maintenance of the engine in the reversed position, you need to turn the
handle to one side, otherwise the bonnet of the engine cannot be opened.
During these operation:
2 – Pull the levers out of their
places
5 – Unlock the lever and with the
other hand rotate the steering
handle
7 – lock the handle by
lowering the lever
OPERATION AND MAINTENANCE MANUAL
3 – Take the levers out of the loops
FOR THE REVERSE, THE
HANDLE SHOULD ONLY BE
TURNED CLOCKWISE
TO GET IT TO ITS NORMAL
POSITION, ONLY
COUNTERCLOCKWISE
8 – put the levers back into the
loops, then in their place and
finally lock them with the split
pins
DANGER OF
BRUISING AND
CRUSHING
Page 10 of 22