Picture 11 - Adjusting Wheels With Flange; Picture 12 - Taking Off The Wheels Spacers - Benassi MC 3300 Operation And Maintenance Manual

In some versions of the machine, you can adjust the track of the wheels, for example to pass more easily
through narrow places.
ONLY TRAINED AND INFORMED STAFF SHOULD PERMORM THESE
OPERATIONS. TURN OFF THE MACHINE AND SET IT ON A FIRM
BEARING IN ORDER TO RAISE THE WHEELS FROM THE GROUND.
You can modify the track of the wheels by inverting the wheels: take off the wheels, then assemble them
again placing outside the internal face and vice versa
Besides, you can adjust the wheels in the following ways as well:
Adjust the position of the
flange in order to place the
wheel more to the inside
or to the outside (only
versions with adjustable
rims)
Picture 11 – Adjusting wheels with flange
Loosen the
screws of the
wheels with a
suitable spanner
(one wheel at a
time)
Loosen the
screws on the
side with a
screwdriver
Loosen the
screws of the
spacer with a
suitable spanner
Assemble the wheel
directly on the axle,
without spacer nor case

Picture 12 - Taking off the wheels spacers

OPERATION AND MAINTENANCE MANUAL
After adjusting the machine, all the
screws should be well tightened and
the implements stable.
Make sure that the machine is
configured symmetrically and is
perfectly stable.
DANGER OF
BRUISING AND
OVERTURNING
Take the wheel
out of the hub
Take out the
spacer case
Take out
the spacer
Page 13 of 22