Xerox Phaser 3300 Servce Manual page 90

Error Messages and Codes
Message
Power Failure
Replace Toner
Retry Redial?
Scanner locked
Self Diagnostic LSU
Self Diagnostic
Temperature
Send Error (AUTH)
Send Error (DNS)
Send Error (P0P3)
Send Error (SMTP)
Send Error (Wrong
Config)
[Stop Pressed]
Toner Empty
Toner Low
Tray 1
Paper Empty
Tray 2
Paper Empty
Nongenuine Toner A
STOP
Nongenuine Toner
Replace Toner 1
3-10
Meaning
Power has turned off then on and the
machine's memory has not been back up.
The print cartridge installed is not a
genuine cartridge.
The machine is ready to redial the most
recently dialed number.
The scanner module is locked
The LSU (Laser Scanning Unit) in your
printer is checking some problems
detected.
The engine in your machine is checking
some problems detected.
There is a problem in SMTP authentication. Configure the authentication setting.
There is a problem in DNS.
There is a problem in POP3.
There is a problem in SMTP.
There is a problem on the network
interface card.
Stop/Clear has been pressed during a fax
transmission.
The print cartridge has run out of toner.
The machine stops printing.
The print cartridge is almost empty.
There is no paper in the tray 1.
There is no paper in the optional tray 2.
The print cartridge installed is not a
genuine cartridge.
The print cartridge installed is not a
genuine cartridge.
Suggested solutions
The job which you were trying to do before the power
failure must be completely re-done.
Replace the print cartridge with a new one.
You can press OK to immediately redial, or Stop/Clear
to cancel the redial operation.
Unlock the scanner and press
Stop/Clear.
Please wait a few minutes.
Please wait a few minutes.
Configure the DNS setting.
Configure the POP3 setting.
Change to the available server.
Configure your network interface card correctly.
Try again.
Replace the print cartridge with a new one.
Take out the print cartridge and thoroughly shake it.
By doing this, you can temporarily re-establish
printing operations.
Load paper in the tray 1.
Load paper in the optional tray 2.
You can select Stop or Continue. It you do not select
any, the printer will work as stop is selected. If you
select stop, you cannot print until the genuine
cartridge is installed. However, you can still print any
kind of reports. It you select continue, you can keep
printing but the quality cannot be guaranteed and the
produce support is no longer provided. If you want to
change the selection, turn the printer off and on to
have this message appear again, and then re-select
stop or continue.
This message appears when you selected stop at the
Non Genuine Toner prompt. Install the genuine print
cartridge.
Phaser 3300MFP Service Manual