Delta 36-960 Instruction Manual page 26

Fig. 93
sticks and feather boards should also be used. Also, the
accessory dado head table insert (E) Fig. 91, must be
used in place of the standard ta b l e i n s e r t .
Fig. 92, shows a typical dado operation using the miter
gage as a guide.
W ARNING: NEVER USE THE DADO HEAD IN
A BEVEL POSITION.
IMPORTANT: ALW AYS INSTALL BLADE GUARD
AFTER OPERATION IS COMPLETED.
USING AUXILIARY WOOD FACING
ON RIP FENCE
It is necessary when performing special operations such
as moulding to add wood facing (A) Fig. 93, to one or both
sides of the rip fence, as shown. The wood facing is
a t tached to the fence with two clamps ( B ) .
s u i table for most work although an occasional job may
require 1 inch facing.
A wood facing should be used when ripping thin material
B
A
3
/ i n c h s t o c k i s
4
C
26
A
Fig. 94
C
B
Fig. 95