Delta 36-960 Instruction Manual page 12

H
J
M
Fig. 37
" wood screws (I) supplied.
3
/
4
2 . Figure 37 illustrates one of the legs (H) fastened to the
bottom of the extension table with the four wood screws
" d r i l l b i t , d r i l l t w o t h r o u g h h o l e s t h r o u g h t h e
( I ) . U s i n g a 1 /
4
end piece (J) of the table, measuring the holes from the
o u tside frame of the ta b l e . The holes are to be drilled
" and 4
from the bottom, and 1 1 /
4
3. Fasten the leg bracket (L) Fig. 38, to the end piece (J)
o f t h e table using the two 1
flat washers and hex nuts (M) Figs. 37 and 38. Fasten the
remaining leg to the extension table in the same manner.
4 . P o s i t i o n t h e table onto the rear rail, making sure there
is clearance for the miter gage slots and blade guard, and
mark the spots t o b e d r i l l e d i n t h e r e a r r a i l t o a t tach the
rear support ta b l e . NOTE: DRILL THE HOLES
THE EDGE OF THE RAIL, AND 7
EDGE OF THE REAR TABLE SO THAT THERE WILL
BE PROPER CLEARANCE
H A R D WARE.
" d r i l l b i t t o d r i l l t h e t w o h o l e s i n t h e r e a r r a i l ,
3
5 . Use a /
16
" from each corner of the table board,
1
approximately 7 /
2
Fig. 39 & 40.
6 . A ft e r t h e h o l e s a r e d r i l l e d i n t h e r e a r r a i l , p o s i t i o n t h e
I
3
" from the side.
1 /
4
" f l a t h e a d P h i l l i ps screws,
1
/
2
" " F R O M
1 /
4
" " FROM
1
/ EACH
2
FOR ATTACHING THE
J L
"
/
4
12
M
Fig. 38
Fig. 39
Fig. 40
Fig. 41