Delta 36-960 Instruction Manual page 11

J
L
M
Fig. 32
3 . Fasten the leg bracket (L) Fig. 32, to the end piece (J)
o f t h e table using the two 1
washers and hex nuts (M) Figs. 31 and 32. Fasten the
remaining leg to the extension table in the same manner.
ASSEMBLING EXTENSION TABLE
TO FRONT AND REAR RAILS
1 . Place table assembly (N) Fig. 34, in position between
the two rails, as shown. Make sure end of ta b l e ( N ) i s f l u s h
against extension wing (P). Using a straight edge make
s u r e table (N) is in the same plane and level with saw table
( P ) . L i g h t l y ta p table up or down and adjust leveling screws
(R) Fig. 33, in bottom of legs to accomplish this. When the
t able (N) Fig. 34 is level and in the same plane with saw
" through holes (S) Fig. 34 through the
1
t a b l e ( P ) , d r i l l /
4
front and rear holes in the guide rail closest to the
extension wing. Fasten both front and rear rail to table
" f l a t h e a d P h i l l i ps screws, flat washers, and
1
using the 1 /
2
hex nuts. Using a level make sure table (N) is in the same
plane and level with saw ta b l e ( P ) . D r i l l
(S) Fig. 34 through the front and rear holes remaining in
t h e g u i d e r a i l .
2 . A fter the holes have been drilled in the edge of the
front and rear extension table board, fasten both front and
r e a r r a i l t o table using the 1
washers, and hex nuts (M) Fig. 31.
ASSEMBLING GUIDE TUBE
TO FRONT RAIL
Lay the guide tube (B) on the saw table as shown in Fig.
35, and line up the threaded holes on bottom of guide tube
(B) with the through holes (D) on the front rail (A). Fasten
the guide tube to the rail using
lockwashers in all of the holes.
REAR SUPPORT TABLE
MOUNTING INSTRUCTIONS
1 . Position the two legs (H) Fig. 36, at the two far corners
of the inside of one end of the extension table, as shown,
and mark the position of the eight holes to be drilled into
the bottom of the table. Remove the two legs (H) and using
" d r i l l b i t , d r i l l t h e e i g h t h o l e s
1
a /
16
legs and fasten to the bottom of the table using the eight
" f l a t h e a d P h i l l i ps s c r e w s , f l a t
1
/
2
" through holes
1
/
4
" f l a t h e a d P h i l l i ps s c r e w s , f l a t
1
/
2
" hex screws and
1 /
2
" deep. Replace the two
1
/
2
B
D
11
R
Fig. 33
P
N
S
Fig. 34
D
Fig. 35
H
I
Fig. 36
A