The following table shows the required adjustments by repaired or replaced part and the order in which the adjustments must be performed. Find the part(s) you repaired or replaced

in the table, and carry out the adjustments in the indicated order.

NOTE 1: Blue cell: indicates that the adjustment is required when the part is once removed or replaced.

Red cell: indicates that the adjustment is required when the part is replaced.

2: The adjustments required for the Main Board differs depending on whether the NVRAM on the old board can be backed up or not.

3: When you repaired or replaced multiple parts, check the order of required adjustments using the sequential mode of the Adjustment Program.

4: When the FW update is required, first check the version of firmware currently installed on the printer, then update the firmware if necessary.

5: If a part is not listed on the table, there is no corresponding test or no need for any adjustment.

6: The tests can be performed before a part exchange to confirm a failure. They can be performed after an exchange to confirm the repair. The tests are not mandatory if

the parts operations can be confirmed in another way.

7: The numbers in the table indicate the order in which the adjustments must be done.

Class

Parts

Housing

PANEL ASSY

FRONT CLEAR COVER

Fans

COOLING FAN PE

COOLING FAN (24V)

VACUUM FAN

COOLING FAN