Epson Stylus Pro GS6000 Service Manual page 148

Epson Stylus Pro GS6000
4.4.9.4 CR LOCK SOLENOID
1. Remove the TOP COVER (right only).
2. Remove the SIDE COVER (right only).
3. Remove the IH COVER (right only).
4. Unlock the Carriage and move it to the center.
5. Disconnect the relay connector at the rear.
As seen from the rear
Relay connector
Figure 4-114. Disconnecting the relay connector at the rear
DISASSEMBLY & ASSEMBLY
(p85)
(p89)
(p90)
(p83)
Disassembly and Assembly Procedure
6. Release the cable from the three clamps.
Clamps to turn
Clamp
Figure 4-115. Releasing the cable
7. Remove the screw from the right that secures the Inner Side Plate.
A) Silver, Phillips, Cup M3x6: one piece
As seen from the right
CR MOTOR
Figure 4-116. Removing the Inner Side Plate (right side)
Revision F
As seen from the top
CR LOCK SOLENOID
Inner Side Plate
A
148
Confidential