Epson Stylus Pro GS6000 Service Manual page 144

Epson Stylus Pro GS6000
4.4.9.2 CR REDUCTION BELT
1. Remove the TOP COVER (L & R).
2. Remove the PANEL COVER, T
3. Remove the SIDE COVER (L & R).
4. Unlock the Carriage and move it to the center.
5. Loosen the two adjustment screws of the Driven Pulley on the left side to relieve
the tension of the CR BELT. See Figure 4-108.
6. Loosen the four screws that secure the CR MOTOR on the right side to relieve the
tension of the CR REDUCTION BELT.
7. Pull the Drive Pulley on the right slightly toward you and draw out the CR
REDUCTION BELT from the space between the frame and the shaft of Driven
Pulley to remove it.
As seen from the right
Draw out from here
Drive Pulley
Figure 4-110. Removing the CR REDUCTION BELT
DISASSEMBLY & ASSEMBLY
(p85)
(p86) and MAINTE COVER T. (p88)
(p89)
(p83)
See Figure 4-120.
CR MOTOR
CR REDUCTION BELT
Disassembly and Assembly Procedure
A D J U S T M E N T Be sure to refer to Chapter 5 "Adjustment"
R E Q U I R E D
specified adjustments after replacing or removing the CR BELT
and the CR REDUCTION BELT.
<Adjustment items>
1. CR Belt Tension Adjustment
2. CR Reduction Belt Tension Adjustment
3. Media Side Margin Adjustment
Revision F
(see p184) and perform
144
Confidential