Epson Stylus Pro GS6000 Service Manual page 138

Epson Stylus Pro GS6000
4.4.8.2 PLATEN HEATER (64)/THERMISTOR, PLATEN
1. Remove the Platen (Step 1 to 3 in 4.4.5.2 VACUUM FAN).
When reassembling the Platen, take care not to catch the cables
between the Platen and the fixing plates.
In the next step, do not touch any screws adjusting the platen
C A U T I O N
(marked with yellow circles in the figure below), or the printer may
not print normally. The screws keep the factory-adjusted
Parallelism.
Inside the Platen
DISASSEMBLY & ASSEMBLY
(p103)
See Figure 4-47.
VACUUM FAN
Disassembly and Assembly Procedure
2. Peel off the heat insulator.
3. Peel off the tape and the PLATEN HEATER(64)s and remove them.
4. Remove the screw and remove the THERMISTOR, PLATENs.
A ) Silver, Phillips, Pan with S.W & P.W M3x5: two pieces
Tape
Platen
THERMISTOR, PLATEN
Figure 4-106. Removing the PLATEN HEATER (64) and THERMISTOR, PLATEN
Revision F
Heat insulator
PLATEN HEATER(64)
Tape
A
138
Confidential