Epson Stylus Pro GS6000 Service Manual page 96

Epson Stylus Pro GS6000
4.4.3.13 REAR PAPER GUIDE
This part is not specified as an ASP.
1. Remove the four screws.
A) Silver, Phillips, Pan with S.W & P.W M4x8: four pieces
2. Slide the REAR PAPER GUIDE toward you a little.
As seen from the rear
Figure 4-34. Removing the screws of REAR PAPER GUIDE
In the next step, do not touch or loosen the screws securing the
C A U T I O N
rollers inside of the printer fixed with thread locker (marked with a
red circle). Otherwise, the printer may not print normally. The
screws keep the factory-adjusted Parallelism.
As seen from the rear
DISASSEMBLY & ASSEMBLY
REAR PAPER GUIDE
A
Do not touch these
Disassembly and Assembly Procedure
3. Open it and disconnect the four connectors, then remove the guide.
2
1
As seen
from the rear
Figure 4-35. Removing the REAR PAPER GUIDE
Revision F
4
3
REAR PAPER GUIDE
Connector
96
Confidential