Replacement Procedures; Replacing The Feed Module Or Feed Module Tires - Kodak i4000 series User Manual

Replacement
procedures
Replacing the feed module
or feed module tires
A-61651 November 2012
This section provides procedures for replacing the following parts. Use the list
below as a guideline for frequency of replacement.
• Feed module tires and separation roller tires — tire life will vary
depending upon paper types, environment and cleanliness. Nominal tire
life is approximately 500,000 documents; results will vary. Degradation of
feeder performance, multiple feeds, stoppages, etc. indicate a need to
change tires. Change all the tires on the feed module and separation roller
at the same time.
• Feed module and separation roller — it is recommended that you install
a new feed module and separation roller every 4th tire change. Install a
new feed module and separation roller at the same time.
• Pre-separation pad — it is recommended that you change the pre-
separation pad at least as often as you change the feed module/separation
roller tires.
• Imaging guides — replace when the imaging guides are heavily
scratched and defects show in the image.
1. Remove the output tray.
2. Lift up and open the printer access cover.
NOTE: If you do not want to remove the output tray, you can lift the front of the
output tray, then lift the printer access cover and position the printer
access cover behind the height adjustment tab.
5-11