Konica Minolta bizhub 250 Ssd Support Solutions page 71

bizhub 250
Solution ID TAUS0801765EN*
Description
FS-xxx, first page not aligned properly/not stapled in stapled sets.
Solution
CAUSE:Static build-up onalignment plate which causes the first page to stick.
SOLUTION:Wipe affected are with anti-static compound (Brillianize®, Pledge®, dryer sheet, etc.).
SPECIAL NOTE : Solution contribution by Chuck Tripp, Production Print/SSD
TAUS0703395EN*
Solution ID
Description
Intermittent jamming/misfeeding from paper cassette(s).
Solution
CAUSE: Paper cassettemoves forward due tomachine vibration. The cassette holder is worn/weak and t he "holding power" hasdecreasedover time.
SOLUTION: The shape of holder has been changed, strengthening the power of cassette hold and by installing a Stop Ring (p/n 4348620600).
Install thecassette holdercountermeasure to preventthe cassette from unlockingas explained inattached Bulletin Number 6217.To viewa PDF, Adobe
Reader® must be installed. Adobe Reader® can be downloaded for free from the Adobe® web site at:
http://www.adobe.com/products/acrobat/readstep2.html .
Solution ID TAUS0801771EN*
Description
Duplex jams and the motor in the turnover unit makes a chattering noise.
Solution
CAUSE: The PWB-A board has failed.
SOLUTION: Replace the PWB-A board (p/n 4040 0101 0E).
Note : When replacing PWB-A make sure to swapthe EEPROM, IC3, on to the replacement board or a C-4721 will be generated.
SPECIAL NOTE : Solution contribution byGerald Koehl of Braden Business Solutions.
TAUS0901405EN*
Solution ID
Description
Jam from all trays. Jams at transfer roller area.
Solution
CAUSE: Damaged driven roller, located below the transfer roller.
SOLUTION: Replace driven roller (p/n 4011 3510 01).Also check the shaft holder on the end, it could be worn.
Copyright 2009, Konica Minolta Business Solutions U.S.A., Inc.
Paper Conveyance jams, no-feed, folding, tearing, skewing, curling
71
Solution Usage 8
6
Solution Usage
Solution Usage 5
2
Solution Usage
October 2009