Chevrolet Light Operator's Manual page 64

Lighting Switch
The lighting switch is mounted near the left end of instru-
ment panel. All current entering the lighting switch passes
through a 30 ampere thermal circuit
breaker. If all lights
faU
to
op~rate
look for trouble at this circuit breaker, the light switch
or the wiring between the battery and light switch. Tail and stop
. lamp circuits are protected by fuses located in a fuse box.
Fuse Box
Description. The fuse. box on all models except Forward Con-
trol units is mounted on the left side of the cowl (fig. 62).
Fuse box on Forward Control units is generally located above
the steering column under the i~strument panel. Twenty ampere
fuses are used for the taillight and stop light circuits. All other
lights are protected by a circuit breaker located in the lighting
switch.
fI9· 62_f .... 801(
The fuse box cover is a snap on type with a. spare fuse clip
containing one fuse located inside the cover.
Fuse Replacement. In case tail or stoplights should fail to
operate it
is advisable to check the fuse
in that circuit. See
Figure 62. Remove the cover. Pull the fuse straight out of the
fuse clips and replace
it
with a fuse
known to be
in good condi-
tion. Place the cover in position and snap into place. In case
the new fuse burns out as soon as the circuit
is
tested, the cir-
• 62'