Chevrolet Light Operator's Manual page 63

fig. ' 58_Removi"g H.od/omp
11m
. fig. 61-0ilco"" • .,1"9 Stal.d
aeom Plug
Co"".dot
Maintenance-
Sealed beam units can be replaced
as follows.
1. Loosen clamp screw and re-
move heacUamp door rim by pulling
it out at bottom and unhooking the
top (fig. 58).
2. Remove the three screws hold-
ing the sealed beam retainer ring
(fig. 59).
NOTE: Do not disturb the head-
lamp adjusting screws on the top
and left s ide of unit (fig. 59).
3. Pull the sealed beam and
retainer ring away from lamp body
and remove retainer ring (fig. 60) .
4. Disconnect wiring plug from
sealed beam unit (fig. 61).
5. Connect wiring plug to new
sealed beam unit, place the retain-
ing ring around unit, push the as-
sembly into place and install the
three attaching screws.
6. Hook the headlamp rim at the
top and pull it down into place.
Install and tighten the clamp screw.
Proper aiming of these powerful
lights is most important to assure
sufficient illumination of the high-
way without blinding other motor-
ists. When light aiming is necessary
it is advisable to contact a Chev-
rolet dealer who has special equip-
ment for this purpose.
The parking, stop and tail lamp
bulbs may be reached by removing
the rim clamp screws, rim and lens.
Push the bulb in slightly and turn it
counterclockwise as far as poSsible
and pull it out of socket. Push new
bulb into place and turn it clock-
wise to lock it. Install rim and lens.
·61·