Chevrolet Light Operator's Manual page 53

left side, open bleeder valve and bleed until all air bubbles dis·
appear. Close bleeder valve.
7. Connect bleeder tube to the front, rear wheel cylinder on
left side, open bleeder valve and bleed until all air bubbles dis·
appear . Close bleeder valve.
8. Connect bleeder tube to left front wheel cylinder, open
bleeder valve and bleed until all air bubbles disappear. Close
bleeder valve.
9. Connect bleeder tube to the rear, r ear wheel cylinder on
the right side, open bleeder valve and bleed until all air bubbles
disappear. Close bleeder valve.
10. Connect bleeder tube to the front, rear wheel cylinder
on the right side, open bleeder valve and bleed until all air
bubbles disappear. Close bleeder valve.
11. Connect bleeder tube to the right front wheel cylinder,
open bleeder valve and bleed until all air bubbles disappear.
Close bleeder valve.
12. Connect bleeder tube to hydrovac slave cylinder, open
bleeder valve and bleed until all air bubbles disappear. Close
bleeder valve.
13. Connect bleeder tube to hydrovac valve bleeder valve,
open bleeder valve and bleed until all air bubbles disappear.
Close bleederiralve.
NOTE: It is Unportant to bl« d the hyd rovac: both before and a rter
bleeding the
wh~l
cylinders.
14. Adj ust upper shoe on each rear wheel.
15. Push down hard on the brake pedal several times to cen·
tralize the shoes, then readjust all brake shoes.
16. Apply approximately 75 pounds pressure on the brake
pedal and check the pedal clearance from the toe board to the
forward edge of the pedal pad. This clearance should be a
minimum of 3ih inches with the floor mat in place.
'51 '