Changing The Administrator Code (Administrator Password) - Konica Minolta bizhub 362 User Manual

Administrator Operations
2.4 Changing the Administrator Code (Administrator
Password)
When access to the Admin. Management mode from the control panel by the
Administrator of the machine is authenticated, the machine enables the op-
eration of changing the Administrator Code (Administrator Password) re-
quired for accessing the Admin. Management mode.
The Administrator Code (Administrator Password) entered for the authenti-
cation purpose appears as "*" on the display.
Note
Be sure to enter an Administrator Code (Administrator Password) that
meets the Password Rules for Administrator Code (Administrator Pass-
word). For details of Password Rules, see "Password Rules" on
page 1-11.
If the Enhance Security function is set to [ON] after an Administrator Code
(Administrator Password) that does not meet the requirements of the
Password Rules, the machine regards any subsequent access for Admin-
istrator authentication as unauthorized access. As a result, access to the
Admin. Management mode can no longer be made. Contact your Service
Representative.
2.4.1 Changing the Administrator Code (Administrator Pass-
word)
Note
Do not leave the machine with the Admin. Management mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Admin. Management mode.
<Setting can be made only from the control panel>
0 For the procedure to call the Admin. Management mode to the display,
see steps 1 through 4 of "Accessing the Admin. Management mode" on
page 2-2.
1
Call the Admin. Management mode to the screen from the control pan-
el.
362/282/222
2
2-15