Table of Contents
Advertisement
2. WIRING
11. For the transducer cable and the cable for the external KP, pass each cable through its
super gland, the supplied rainproofing panel and each hole in the unit. Then slip a lock nut
onto each cable. (For the super gland of the cable for the external KP, unfasten the lock nut
from the super gland then pass the cable through the super gland. See page 8 for how to treat
the cable end.)
After passing the cable for the external KP, do as follows:
- Assemble the super gland.
- Tighten the sealing nut until the clearance is 4 mm. The torque shall be 1.8 - 2.0N/m.
Cable for
Ext. KP
(MPYC-4)
Super gland
Sealing nut
14
Lock nut
Rainproofing panel
4 mm
Advertisement
Table of Contents
