2.2.2
How to connect the transducer cable
This procedure shows you how to connect the transducer cable. To connect both the transducer
cable and the cable for external KP, go to section 2.2.3.
1. Open the cover: Grasp the cover at two sides, spread the cover slightly and lift.
2. Loosen five screws to remove the shield cover.
3. Detach the two WAGO connectors (TB3, TB4) inside the equipment.
4. Unfasten the sealing nut from the super gland for the transducer cable.
TB4
TB3
Sealing nut
9
WAGO connector
Clamp fixing plate
WAGO connector
opener
2. WIRING