Table of Contents
Advertisement
2. WIRING
5. Loosen the two screws fixing the clamp fixing plate to detach the plate.
6. Pass the sealing nut (unfastened at step 4) onto the transducer cable and pass the cable
through the super gland and into the unit.
7. Use the WAGO connector opener, attached inside the equipment, to connect the transducer
cable to the WAGO connectors, following the instructions in the figure below and the intercon-
nection diagram.
Twist.
Core
8. Attach the WAGO connectors.
9. Refasten the clamp fixing plate, referring to the table below for how to orient the plate.
Transducer type
CM265LH
B265LH
Push
WAGO connector opener
1. Twist conductors.
2. Insert opener as directed and press it down.
3. Insert core to hole.
4. Release opener.
5. Pull the core to make sure it is correctly inserted.
Clamp fixing plate orientation
Projection on plate upward
Projection on plate downward
10
Clamp fixing plate
Advertisement
Table of Contents
