Table of Contents
Advertisement
GLASS PANORAMIC ROOF
(TOURER)
4
This device comprises a tinted glass
panoramic surface 1 to improve
brightness and vision in the passenger
compartment.
It is fi tted with an electrical blind 2
to help maintain a comfortable tem-
perature and reduce noise.
SEQUENTIAL ELECTRICAL
BLIND
80
A C C E S S
Opening
Press control A .
Pressing to the 1st notch allows you
to open the blind step by step.
Pressing to the 2nd notch allows
you to fully open the blind.
The blind stops in the closest pre-
defi ned position (11 positions) as
soon as you release the control.
Closing
Press control B .
Press to the fi rst notch to close the
blind step by step.
Press to the second notch to close
the blind completely.
The blind stops at the nearest pre-
set position (11 positions) as soon as
you release the control.
Anti-pinch
If the blind meets an obstacle whilst
closing, it stops and opens partially
again.
You must re-initialise the anti-pinch
function within 5 seconds of the
blind stopping:
press control B until the blind is
fully closed (closing in steps of a
few centimetres).
After a battery disconnection, or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function:
press control B to the 2
(fully closed),
wait
until
the
blind
closed,
press control B for at least 3 seconds.
If the blind opens randomly during a
closing operation, and straight after
the blind stops:
Press control B until the blind
closes fully.
During these operations, the anti-
pinch function does not operate.
In the event of anything being
caught when the blind is moving,
you must reverse the movement of
the blind. To do so, reverse the po-
sition of the control.
When the driver is operating the
blind, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that his pas-
sengers are using the blind correctly.
Pay special attention to children
when operating the blind.
notch
nd
is
fully
Advertisement
Table of Contents
