Table of Contents
Advertisement
Storing driving positions
System which takes into account the
settings of the driver's seat, exterior
mirrors and air conditioning. It ena-
bles you to store up to two positions
using the buttons on the side of the
driver's seat.
C O M F O R T
Storing a position
Using buttons M/1/2
Switch on the ignition.
Adjust your seat and your exte-
rior mirrors.
Press button M , then press but-
ton 1 or 2 within four seconds.
An audible signal is heard indi-
cating that the storing has been
taken into account.
Storing a new position cancels the
previous position.
For your safety, avoid storing a
driving position while driving.
Recalling a stored position
Ignition on or engine running
Briefl y press button 1 or 2 to re-
call the corresponding position.
An audible signal is heard indicating
the end of the adjustment.
When the ignition is on, after a few
consecutive
position
recalls,
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery.
REAR HEAD RESTRAINTS
The rear head restraints can be re-
moved and have two positions;
-
high, position for use,
-
low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high po-
sition, push the lug and pull it up-
wards.
To refi t it, engage the head restraint
rods in the holes taking care to re-
main in the centreline of the seat
back.
the
Never drive with the head restraints
removed, they must be in place
and correctly adjusted.
3
59
Advertisement
Table of Contents
