3.2
Configuring WLAN Settings
All of the features you configure in this section are within the WLAN tab on the D-LINK
Wireless Switch.
3.2.1 Configure the Basic Settings
Use the following steps to configure the Wireless Switch and the APs.
1. On the Global tab of the Administration
switch IP address is the Loopback interface address (192.168.10.254), the country
code is correct, and that the WLAN Switch Operational Status is Enabled.
2.
Click Next to go to the Discovery tab on the Basic Setup page.
3.
Add the IP address for AP2 (172.17.6.1, which is on the "customer" network) to the
L3/IP Discovery list, and then click Submit (Note: since you do not know for sure which
IP address the DHCP Server on the "customer" network will provide to AP2, you can
configure a range of IP addresses to add to the L3 Discovery list).
4.
Click the SSID tab to configure the VAP and Network settings for the L3-Tunnel
network..
5.
Select the 802.11b/g radio.
6.
Select the check box next to Managed SSID 4 and click Edit.
7. Change the following Network parameters and select Submit:
b. SSID – L3-Tunnel
c. L3 Tunnel Check Box: Enabled
d. L3 Tunnel Subnet: 192.168.250.0
e. L3 Tunnel Mask: 255.255.255.0
Basic Setup page, make sure the